Brock's Performance Products Homepage Brock's Performance Products Homepage

Welcome Guest Register Login Search The Forum Display List of Forum Members
 All Forums
  The ACTION ! - Brock's Question and Answer Forum 		 
Subject Topic: 2007 gsxr 1000 clutch mod Post Reply Post New Topic
Message posted by bink on March 03 10 at 11:15pm - IP Logged
View bink's Profile Search for other posts by bink Quote bink
bink
Standard Member
Standard Member
United States
September 02 09
9 Posts
I am running the clutch mod for 2007 gsxr 1000. My aluminum plate is warped. It measured same thickness of a steel plate. I placed steel plate in place of aluminum plate. should this cause problems. I havent noticed any as of yet, raced bike appears fine. just wanted make sure. If it is okay, then why send aluminum instead of steel. Aluminum would warp easier?

Message posted by *EJ* on March 04 10 at 10:05am - IP Logged
View *EJ*'s Profile Search for other posts by *EJ* Visit *EJ*'s Homepage Quote *EJ*
*EJ*
Avatar
Forum Moderator
Forum Moderator

January 19 04
487 Posts

bink,

The steel will work ok but the aluminum plate is lighter and when the springs are installed the aluminum will get flat the steel will not.

The plates have two coatings, the first is a military hardcoat anodize, second is tungsten.

If you wish to post a reply to this thread you must first Login
If you are not already registered you must first register

Forum Jump Post Reply Post New Topic
Printable version Printable version

Powered by Web Wiz Forums version 6.32
Copyright ©2001-2002 Web Wiz Guide