Brock's Performance

Search Results
You searched for "after"

32 FAQs Found
Page 1 of 4
Does Brock's recommend the use of K&N or BMC aftermarket street or race air filters?
 
Clutch mod and HD springs: I have both in my Suzuki GSXR 1000 05". What I need help with is the clutch adjustment after both are installed. I see there are 3 adjustment areas; 1) the lever 2) the clutch release adjuster cap 3) and the clutch cable adjuster under the tank. How should all three be adjusted for the correct setting? Here is what I've noticed, when I leave free play at the lever it's hard to engage the gears but when it's tight at the lever it's no problem. I've followed your instructions to the tee and still it boggles me. I guess I don't know what I should expect with having your mods in there. Also where should the clutch start to grab? Very soon from the handle or in the middle? This has been racking my brain since I've owned the bike.
 
If you replace your stock pipe with an aftermarket pipe, would a power commander be necessary?
 
Why does my bike miss and not idle below 5k after I installed the exhaust, PAIR block off, and air box mod?
 
After approval, do I need to fill out a previously approved map support form every time I would like to request a new map?
 
I have installed the Ultra Clutch Mod, and at first it seemed like the clutch was engaging at the half way point of clutch lever, but after a couple of hard launches it seems to be engaging more towards the almost full out. How do I set the clutch at the adjuster and know its right?
 
I have a '07 ZX14 and I'm considering your Street Meg pipe but have a few questions. 1)I already have a PC3 Power Commander and the secondary throttle plates out(map 011),what horsepower and torque gain can I expect after remapping with your pipe? 2)What is the cost including shipping to Edmonton,Ab.Canada including all fees? 3)Does a full system have an advantage over slip-ons other than weight saving?
 
I have a ZX14 that I want to put a sidewinder on, but first I have a few questions: Do you need a cut oil pan? Can you remove the oil filter without removing the pipe? Do you have to remove your oil cooler? Is the rear brake usable after install?
 
I just installed a Two Brothers full system on a ZX12R, it still has stock air cleaners, should I get after market air cleaners for full benefit? Do you have any recommended maps?
 
After an accident, how will I know if my BST wheel is still safe and usable?
 
Go to Page :

Can't Find an Answer?
If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.

Back to Top