You searched for "Hayabusa,"
76 FAQs Found
Page 1 of 8
My FI light shines when I installed your pipe on my 2008 Hayabusa. What do I do with the O2 Sensor?
I have a 2005 Hayabusa with your clutch mod. For some reason the clutches don't last long. What could be the problem?
I replaced the K&N air filter with the stock air filter and ran redline fuel injector cleaner thru the system. New result is 157.87 hp @ 92.61 ft/lbs. (higher ambient temp /lower humidity) When I changed the filter, the idle dropped, and I had to adjust the idle up to keep it running. I would think this is more restriction? The dyno shows the bike is now running richer than with the K&N filter, but producing more power?? People have suggested dyno tuning the bike, I wanted to get yor input before doing this.
My Suzuki GSX-R1000 (Or Hayabusa) misses and stalls abruptly when I pull the clutch lever in – Do I need a Map? Is my Power Commander bad?
How much power does your clutch cushion kit hold up to for the GSXR1000s and Busas? I have been using a lock up and have had nothing but problems.
I have the air box mod instructions for my GEN 1 Hayabusa. I don't have a Power Commander, but wanted to know if this modification would improve my mileage and horsepower. I have OEM air filter and Yoshimura Bling 22 4-into-2 exhaust.
What is the best oil and weight to run in my 1397 Hayabusa.
I have a street megaphone on a Hayabusa with small box mod, stock filter, PC3USB, 87 pump gas? I have a flat spot with hesitation from 2500 to about 3300. Which map do you recommend for it? Don't want it to run too lean.
Will an intake cam on the exhaust side work with my slip on GP style short pipes on my 09 Hayausa? Or do I need to change the whole exhaust system for it to work?
2002 Hayabusa 1397. I have your piston kit, intake cam, exhaust cam, sidewinder. Also PC III USB, 10 inch over swingarm, 60hp shot wet nitrous. It has no air filter(block-off plate) and used as a track bike only. 1. What type of fuel do you rec? 2. Do you have a map available? 3. Should I run baffle or not? 4. What be proper gearing, I weigh 200 lbs? 5. I have a MRE lock-up, should I run your spring package as a baseline? 6. How much can you safely spray until you have to take timing out?
Go to Page :
Can't Find an Answer?
If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.