You searched for "GSX-R1000,"
45 FAQs Found
Page 1 of 5
My Suzuki GSX-R1000 (Or Hayabusa) misses and stalls abruptly when I pull the clutch lever in – Do I need a Map? Is my Power Commander bad?
How much power does your clutch cushion kit hold up to for the GSXR1000s and Busas? I have been using a lock up and have had nothing but problems.
Can you send me a map with the secondary throttle plates removed for a GSX-R1000? Also does Pair valve sucker mod in place mean that the Pair valve has been removed?
I installed your ultra clutch mod and yellow springs. Now, when I am on the line can I just dump it (does it drag or slip by itself and then bite) or do I still have to drag it? Is there more than one way of setting the clutch? I saw something about washers behind the springs? I am running 14-46 gearing and trying to keep the front end down through the end of first. I have a GSX-R1000 that's lowered and strapped with weights.
Clutch mod and HD springs: I have both in my Suzuki GSXR 1000 05". What I need help with is the clutch adjustment after both are installed. I see there are 3 adjustment areas; 1) the lever 2) the clutch release adjuster cap 3) and the clutch cable adjuster under the tank. How should all three be adjusted for the correct setting? Here is what I've noticed, when I leave free play at the lever it's hard to engage the gears but when it's tight at the lever it's no problem. I've followed your instructions to the tee and still it boggles me. I guess I don't know what I should expect with having your mods in there. Also where should the clutch start to grab? Very soon from the handle or in the middle? This has been racking my brain since I've owned the bike.
What are the expected gains going from stock everything to a Brock's Full Exhaust and PCV with Map in a GSX-R1000? I know there are a few more factors involved in this equation but I would like rough estimate. Thanks
Do pair block offs work with the GSX-R1000?
Does the oil cooler removal kit work for the GSXR1000?
I have a 2006 Gsxr1000, today I tried to start my bike and the only thing it did was turn over. I checked my gas tank it was low on fuel so I put some fuel in it, but it still wouldn’t start. I checked the fuses and the battery and there was nothing wrong with them. Could the spark plugs be fouled?
I have installed the Ultra Clutch Mod, and at first it seemed like the clutch was engaging at the half way point of clutch lever, but after a couple of hard launches it seems to be engaging more towards the almost full out. How do I set the clutch at the adjuster and know its right?
Go to Page :
Can't Find an Answer?
If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.